See also Best Portable Dartboard Stand
Identify exactly where you'd like to setup the dartboard. Spot the board within a clearing exactly where it will likely be simple to retrieve any fallen darts. Dig out two holes inside the ground, 25 inches apart and two feet deep.
Mix the bag of concrete inside the bucket by following the directions around the bag. Place certainly one of the 4-inch by 4-inch posts into among the holes and pour concrete in to the hole when holding the post straight. Repeat this method for the second post. The posts must be aligned and straight when you are completed. Let the concrete dry for the level of time specified around the bag.
Measure two feet down in the best of a post and mark it. Do the exact same for the second post. Around the plyboard, measure and mark 5 in addition to a half inches from every single side on the board.
Spot the board in order that the bottom of your board reaches the two-foot marks you created around the posts. The sides with the posts need to be in the marks you produced around the board. Nail the board for the posts making use of at the very least two nails for every single post.
Measure ten 3/4 inches down in the major on the board and make a mark. Then measure 20 inches in the side and mark the center. Hammer a nail partially in to the board in the spot ten 3/4 inches in the top rated and centered in the sides. Hang your dartboard in the nail and start a game of darts.
Things Needed
- 2 posts, 8 feet by 4 inches by 4 inches
- 1 plyboard, 40 inches by 40 inches
- 7 nails, 3 1/2-inch
- 2 bags of cement, 80 lbs. each
- 1 bucket, 20-gallon
- Shovel
- Safety glasses
- Tape measure
- Dartboard
How to make a dartboard stand video
Tags
Info